NEW Co-Pilot II LT Combo1

NEW **** SPECIAL OFFER *****Co-Pilot II 4 Channel Flight Stabilisation System

Our Price:
£69.00
Notify Me
Description

The new, lower cost CPII LT systems are fully-operational flight stabilization systems. They have all of the features available in the original CPII systems except that they do not include the IRNet Programmer or IRNet Router. Programming is done via the FREE "Co-Pilot II Display Software". Pre-flight weather check, as well as system error messages are provided by means of the new CPII Go LED. This information is available at the blink of an eye and provided in real-time via the Go LED's 3 super-bright LED's. CPII LT Comob 1 is the basic LT system. All features are similar to the other combo, but without the vertical sensor, automatic weather calibration is not available. Calibration is easily accomplished with the push of the MODE button on the Go LED. Calibration should be performed 1 time per flying day, or whenever the weather conditions change drastically. Be sure to download the CPII Go LED manual from the link provided below. Also, without the vertical sensor installed, the aircraft is likely to recover from inverted flight using a split-S maneuver (half of an outside loop) which, if the aircraft is not at high enough altitude can result in contact with the ground. The vertical sensor, when installed, always forces Co Pilot II to roll the aircraft from inverted flight with little loss of altitude. Finally, without the vertical sensor, certain 3D flight modes such as knife edge and vertical hover are not possible. CPII LT Combo 1 does include the FUIM3 PC USB interface which means you will be able to access automatic firmware updates using a personal computer running Windows operating systems, and you will be able to program and access all features of the CPII using your Windows based PC.

Revolectrix Shopping Cart

 x 
Cart empty